Natal Railway 0-4-0WT Natal

Natal Railway 0-4-0WT Natal
NGR 0-4-0WT Natal

The reconstructed engine Natal, Durban station
Type and origin
Power type Steam
Designer Carrett, Marshall & Company
Builder Carrett, Marshall & Company
Build date 1860
Total produced 2
Specifications
Configuration 0-4-0WT (Four-coupled)
Driver 2nd coupled axle
Gauge 4 ft 8 12 in (1,435 mm) broad
Coupled dia. 45 in (1,143 mm)
Wheelbase 9 ft (2,743 mm)
Length:
  Over beams 17 ft 6 in (5,334 mm)
Height 12 ft (3,658 mm)
Loco weight 12 LT (12,190 kg)
Fuel type Coal
Firebox type Round-top
Boiler:
  Pitch 5 ft (1,524 mm)
Cylinders Two
Couplers Buffers-and-chain
Performance figures
Power output Approximately 24 hp (18 kW)
Career
Operators Natal Railway Company
Natal Government Railways
Number in class 1
Official name Natal
Delivered 13 May 1860
First run 1860
Last run 1875
Withdrawn 1875

The Natal Railway 0-4-0WT Natal of 1860 was a South African steam locomotive from the pre-Union era in the Natal Colony.

The first locomotive to run in revenue service in South Africa, the Natal Railway Company's engine Natal, was landed at Durban Harbour on 13 May 1860. It made its inaugural run on 26 June 1860, during the official opening of the first operating railway in South Africa.[1][2]

The locomotive Natal

The first revenue-earning railway service in South Africa commenced in Durban in the Colony of Natal on 26 June 1860. The train was hauled by a small broad gauge 0-4-0 well-tank engine named Natal, which was landed at Durban Harbour off the brig Cadiz on 13 May 1860. The engine arrived stripped down and was erected by Henry Jacobs, engine fitter, driver and locomotive superintendent of the Natal Railway Company, assisted by Alexander Davidson, chief smith, fitter, springmaker, platelayer and head of the repair shops. A young seaman named Austin was taken on as cleaner and greaser, and ultimately promoted to stoker. A station on the Bluff was later named after Henry Jacobs.[1][2][3]

The locomotive Natal was, however, not the first locomotive to arrive in South Africa, having been denied that honour by nine engines in the Cape of Good Hope. These were Blackie, the 0-4-0T construction locomotive which had arrived in Cape Town on 8 September 1859, and the eight 0-4-2 tender locomotives of the Cape Town Railway and Dock Company which had arrived in two shipments on 20 March and 28 April 1860 respectively.[1][2]

Although the Cape's construction locomotive had possibly been used before June 1860 on the construction of the Cape Town-Wellington Railway, a project which had commenced on 31 March 1859, official revenue-earning railway operations in the Cape only commenced when the first section of the line, between Fort De Knokke and Salt River in Cape Town, was officially opened on 8 February 1861.[1]

Manufacturer

For many years credit as the locomotive builder of the engine Natal had been attributed to the City of London Engine Works, the London company of Robert Legg, but subsequent research showed that Robert Legg was merely the agent through whom the shipping of the locomotive to Durban was arranged. The actual manufacturer was a firm by name of Carrett, Marshall and Company of Leeds, while Robert Legg was its London agent. Further research by a member of the Railway Society of Southern Africa has shown that at least two of these locomotives were built, the other having gone to the Caribbean to work in the sugar industry.[4][5][6]

The engine carried its water in a well-tank and the coal in a locker on the footplate. A donkey pump on the coal locker fed water to the boiler. The chimney had an inverted conical shape and the wide opening was covered by wire mesh, to serve as a spark arrester. The locomotive was erected in a tarred timber shed on Market Square in Durban and was painted green, with copper-coloured wheels and with a huge polished brass dome cover.[1][2]

Service

When the locomotive arrived in Durban, the railway had already been in use for some time, but until then the railway trucks were hauled by oxen. The Natal Railway's initial rolling stock consisted of six to eight trucks, two travelling cranes and one passenger coach.[2][3]

Natal arriving at Point Station on its inaugural run in June 1860

According to most publications, the official opening of the newly mechanised Natal Railway took place on Tuesday, 26 June 1860, a little more than a month after the engine arrived. The inaugural run was at 11:00 along a 2-mile (3.2-kilometre) stretch from the Market Square Ordnance Reserve in Durban to the newly built Point station at Durban harbour, near the Custom House. This was followed by passenger rides for the public for the rest of the day, at a return fare of one shilling. The day's festivities ended with a ball in the Masonic Hall.[1][2][7]

Commemorative plaque on Natal

According to the plaque on the reconstructed locomotive, however, the date of its first run was 23 June 1860. In fact, both these dates are correct since a trial run had been conducted three days before the official inauguration, on Saturday afternoon, 23 June 1860. After testing the locomotive over a short distance, the passenger coach was coupled and the train set off to the Point with the company chairman and secretary as passengers. At the Point it collected five trucks loaded with some 40 tons of sugar-mill machinery and some standing passengers.[7]

The locomotive gave satisfactory service for several years, but was plagued by the sandy conditions of the track, which resulted in damage to moving parts from dust and beach sand. The constant repair work which this required, led to frequent delays. The locomotive was eventually transferred to Port St. Johns, where it was used on the harbour works.[1][2][3]

Nationalisation

A second locomotive was acquired by the Natal Railway Company in 1865, a 0-4-0 saddle-tank locomotive named Durban. By 25 January 1867, the line had only been extended a further 3 12 miles (5.6 kilometres) to Umgeni, from where stone, quarried from the Umgeni River, was transported to the harbour.[1][3][8]

No further railway development took place in Natal until 1875, when the Natal Government Railways (NGR) was established. On 1 January 1877, all the assets of the Natal Railway Company were taken over by the Colonial Government and it became part of the NGR. Since the Government had decided to implement Cape gauge, in conformance with the railways in the Cape of Good Hope, and to extend the lines inland to Pietermaritzburg, up the north coast to Verulam and down the south coast to Isipingo, the existing tracks were regauged and the railway service life of the engine Natal came to an end after only fifteen years.[1][3]

Superstition

The engine Natal was put up for sale and purchased by a Mr. Crowther, who intended to use it to drive a sawmill on his farm at Port St. Johns. He was, however, unable to make use of it since the local population labour force objected to this "devil's machine" and embarked on a boycott, culminating in Crowther having to abandon his farm, and the engine.[1][3]

The remains of Natal being exhumed
Natal in Durban shops, 26 June 1944

In 1886 one Alex Anderson purchased the farm for sugar planting, but when he decided to use the engine to drive a sugar mill, another early example of South African rolling mass action ensued and he, too, was forced to leave.[1][3]

The farm was then acquired by one Harry Cooper, who buried the engine on the banks of the Mzimvubu River. He was left unmolested thereafter and proceeded to grow tobacco. Cooper remained on the farm until 1901, when he sold it to one Sam Clarke of Umtata, who converted the property into a fruit farm. By this time the actual location of the locomotive's grave had become lost.[1][3]

Resurrection

On 28 May 1943, the late Theo Espitalier, who had been commissioned to prepare a history of the locomotives of South Africa, managed to locate the grave of the engine Natal. The remains were excavated and transferred to Durban, arriving there on 26 June 1944, eighty-four years to the day after this engine had hauled the first train in South Africa.[1][3]

The frame, the wheels, the springs, the cylinders and some odd loose parts were literally all that remained of the old locomotive. The engine was reconstructed in the Durban workshops of the South African Railways, with many missing parts having to be fashioned to approximately the original shape and size. It was plinthed at Durban station, where it was officially unveiled by the Mayor of Durban, Senator S.J. Smith, on 9 September 1946. Even though it was not an exact reconstruction in every sense of the word, it was sufficiently close to the original to represent what the engine may have looked like on the day the South African Railways was born in 1860.[1]

References

Wikimedia Commons has media related to Natal Railway 0-4-0WT Natal.
  1. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Holland, D.F. (1971). Steam Locomotives of the South African Railways, Volume 1: 1859-1910 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 11, 20–21, 84. ISBN 978-0-7153-5382-0.
  2. 1 2 3 4 5 6 7 Espitalier, T.J.; Day, W.A.J. (1943). The Locomotive in South Africa - A Brief History of Railway Development. Chapter I - The Period of the 4 ft. 8½ in. Gauge. South African Railways and Harbours Magazine, June 1943. pp. 437-440.
  3. 1 2 3 4 5 6 7 8 9 The South African Railways - Historical Survey (Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd, Circa 1978, pp. 5-8.)
  4. Natal Society Foundation 2010 - Natalia 40 (2010) p20–31 - The first public railway in South Africa: The Point to Durban railway of 1860
  5. Carrett Marshall & Co., Sun Foundry, Dewsbury Road, Leeds
  6. Grace's Guide – The Best of British Engineering 1750-1960s
  7. 1 2 Heydenrych, Heinie and Martin, Bruno (1992). The Natal Main Line Story, Chapter 1: Railway Proposals and a Small Beginning, 1859-1875. HSRC Publishers, Pretoria. p. 1. ISBN 0 7969 1151 7.
  8. It's a Puzzlement, Article by Bruno Martin, SA Rail December 1990, pp. 214-215.
This article is issued from Wikipedia - version of the 9/14/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.