CSX Susquehanna River Bridge

CSX Susquehanna River Bridge

Susquehanna River Bridge circa 1978
Coordinates 39°34′08″N 76°05′13″W / 39.56884°N 76.0870°W / 39.56884; -76.0870 (CSX Susquehanna Bridge)Coordinates: 39°34′08″N 76°05′13″W / 39.56884°N 76.0870°W / 39.56884; -76.0870 (CSX Susquehanna Bridge)
Carries CSX Philadelphia Subdivision (1 track)
Crosses Susquehanna River
Locale Havre de Grace, Maryland and Perryville, Maryland
Owner CSX Transportation
Characteristics
Design Through truss and deck truss
Material Steel
Total length 6,109 feet (1,862 m) [1]
Longest span 520 feet (160 m) [1]
Clearance below 85 feet (26 m) [2]
History
Constructed by American Bridge Company [3]:48
Opened January 6, 1910 [4]:106
Susquehanna River Bridge

The CSX Susquehanna River Bridge is a railroad bridge that carries CSX's Philadelphia Subdivision across the Susquehanna River between Havre de Grace and Perryville, Maryland, via Garrett Island. It was built in 1907-10 by the Baltimore and Ohio Railroad (B&O) on the same alignment as an 1886 B&O bridge. Like its predecessor, it was the longest continuous bridge on the B&O system.[4]:43,105

History

1866-1884: PW&B Bridge

The 1866 completion of the nearby Philadelphia, Wilmington, and Baltimore (PW&B) railroad bridge allowed trains between Baltimore and Philadelphia to cross the Susquehanna without the aid of a ferryboat for the first time.[5]:111,114 The B&O used trackage rights on the PW&B to operate trains to Philadelphia and Jersey City starting at about this time. In this way, the B&O was able to expand its service territory with minimal capital expenditure.[4]:20–21

In 1869, the B&O began advertising this route as the “New York and Washington Air Line Railway.” Although the PW&B was an independent company at the time, the use of key sections of track in Philadelphia and New Jersey depended upon the cooperation of the Pennsylvania Railroad (PRR). When the B&O's president John W. Garrett was outbid by the PRR for control of the PW&B in early 1881, Garrett realized that B&O's Philadelphia and New York connections were in jeopardy. B&O began planning immediately for its own line between Baltimore and Philadelphia, where a connection to the friendly Reading Railroad would provide access to the New York area.[4]:26–29[6]

B&O passenger trains continued crossing the river on the PW&B until the trackage rights agreement expired on October 12, 1884.[4]:34

1884-1907: First B&O Bridge

B&O's new line, the Baltimore and Philadelphia Railroad, was built to higher engineering standards than typical on its system, despite the company's shaky finances.[4]:22,42–43 At the Susquehanna, the B&O resolved to create a bridge that was superior to the PW&B bridge it formerly used. As Garrett wrote in an 1884 report:

It...will be one of the largest and most remarkable structures of its class in the world. It is the determination of the company that it shall be of the most substantial, safe and durable character. It will be 6,346 feet [1,934 m] in length, 94 feet [29 m] above low mean tide, and will rest on eleven granite piers, having their foundations on the bed-rock of the river... The foundations for six of the piers have been difficult, reaching, as they do, a depth of 85 feet [26 m] below low water, and necessitating the use of caissons, with air chambers, in which the men, engaged in removing the debris in order to reach bed-rock, have worked under a pressure of 37 pounds per square inch [260 kPa]. [3]:46–48
Western end (from Havre de Grace)
Eastern end (from Perryville)
1886 B&O Susquehanna Bridge

The bridge consisted of the following segments: a 212-foot (65 m) western approach viaduct, four 480-foot (150 m) Whipple deck truss spans, a 520-foot (160 m) through truss span over the western navigation channel, a 200-foot (61 m) deck truss span, a 1,942-foot (592 m) viaduct over Garrett Island, one 380-foot (120 m) and one 520-foot (160 m) Whipple deck truss spans, a 380-foot (120 m) through truss span over the eastern navigation channel, and finally a 242-foot (74 m) eastern approach viaduct. The eastern approach also crossed the PRR's Columbia and Port Deposit Railroad. Unlike the remainder of the Philadelphia line, the bridge contained only a single track.[3]:45[7]:12[note 1]

The bridge cost $1.7 million to construct. It was opened with a ceremonial train on May 11, 1886. Freight operations began on May 25 of that year; passenger operations followed on August 23. The first Washington to New York train to use the new route crossed on December 15. Starting in 1890, passenger trains that used the bridge were marketed under the name Royal Blue Line.[4]:39–41,43,75–76

1908-present: Second B&O Bridge

In the early years of the 20th century, the iron bridges on the Philadelphia line could no longer handle the latest locomotive designs at optimal speeds. The Susquehanna Bridge also required an additional track. In November 1907, the American Bridge Company and Eyre-Shoemaker Company began renovating the structure. Timber falsework was used to shore up sections of the bridge under construction, allowing construction to proceed with minimal disruption to traffic.[3]:48[1][4]:105–106

On September 23, 1908, a coal car derailed on the bridge and struck a mobile crane. The crane collapsed, bringing down the eastern channel through truss, which sank in deep water. One person was injured and 12 cars at the end of the train were lost.[3]:48,50[8]

The PRR granted the B&O the right to detour trains over its new double-track bridge, and so track connections between the B&O and PRR were built at Swan Creek (west of Havre de Grace) and Aiken (near Perryville). At Aiken, the steep grade between the two lines required the use of helpers. This detour was maintained while the renovations to the Susquehanna Bridge were completed.[8]

Western end (from Havre de Grace)
Eastern end (from Perryville)
1908 B&O Susquehanna Bridge

Compared to the original bridge, the new bridge has shorter and more numerous deck truss spans.[4]:106 The superstructure is constructed of 16,000 short tons (15,000 t) of steel and can support two tracks. Pennsylvania through truss spans are used over both navigation channels.[7]:21 30 new piers were built; 10 were widened and remodeled. Three of the new piers were sunk in the west channel using the caisson process.[1]

The renovations cost more than $2 million. The new bridge opened for traffic on January 6, 1910.[1]

Passenger service east of Baltimore ended on April 26, 1958. By 1960, the entire Philadelphia line including the Susquehanna Bridge was single-tracked. Ownership of the bridge later passed to the Chessie System and CSX along with other B&O assets.[4]:170–175

Present status

As of 2006, CSX runs about 24 trains daily on the Philadelphia Subdivision, including intermodal, autorack, and general merchandise freights.[9]

See also

Notes

  1. The lengths of the three spans on the eastern side of the river are surmised from the 1914 B&O truss bridge report. The Baltimore Sun article of May 10, 1886, quoted by McCrain says the through truss section is 520 feet. The B&O report assigns this length to one of the deck truss sections instead.

References

  1. 1 2 3 4 5 "The B&O Bridge at Havre de Grace", Railway Age Gazette, 48 (3): 154, January 21, 1910
  2. "Nautical chart for Perryville vicinity". Maptech MapServer. Retrieved November 19, 2011.
  3. 1 2 3 4 5 McCrain, John (2002), "Six Susquehanna Bridge Crossings: Thirteen Bridges", Harford Historical Bulletin, 92 (Spring), ISSN 0741-7802
  4. 1 2 3 4 5 6 7 8 9 10 Harwood, Jr., Herbert H. (2002). Royal Blue Line: The Classic B&O Train Between Washington and New York. Johns Hopkins University Press. ISBN 0-8018-7061-5. Retrieved November 20, 2011.
  5. Roberts, Charles S.; David W. Messer (2003). Triumph VI: Philadelphia, Columbia, Harrisburg to Baltimore and Washington DC: 1827-2003. Baltimore, Maryland: Barnard, Roberts, and Co., Inc. ISBN 0-934118-28-0.
  6. Bommer, Edward F. "The Baltimore & Ohio Railroad in New Jersey". Retrieved November 25, 2011.
  7. 1 2 Various Types of Truss Bridges (PDF), Baltimore, MD: Baltimore & Ohio Railroad Company, Office of the Engineer of Bridges, March 23, 1914, retrieved January 3, 2010
  8. 1 2 Hall, Richard E. (February 2005), "Swan Creek Track Connections", Transfer Table, Wilmington, DE: Wilmington Chapter, National Railway Historical Society, 27 (2), retrieved November 20, 2011
  9. Volin, Rudy (July 6, 2006). "Hot Spots: Perryville and Havre de Grace, Md.". TRAINS Magazine. Retrieved November 22, 2011.
  • Stover, John F. (1995). History of the Baltimore and Ohio Railroad. Purdue University Press. p. 166. ISBN 978-1-55753-066-0. 

External links

This article is issued from Wikipedia - version of the 9/30/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.