Transportation forecasting

Transportation forecasting is the attempt of estimating the number of vehicles or people that will use a specific transportation facility in the future. For instance, a forecast may estimate the number of vehicles on a planned road or bridge, the ridership on a railway line, the number of passengers visiting an airport, or the number of ships calling on a seaport. Traffic forecasting begins with the collection of data on current traffic. This traffic data is combined with other known data, such as population, employment, trip rates, travel costs, etc., to develop a traffic demand model for the current situation. Feeding it with predicted data for population, employment, etc. results in estimates of future traffic, typically estimated for each segment of the transportation infrastructure in question, e.g., for each roadway segment or railway station.

Traffic forecasts are used for several key purposes in transportation policy, planning, and engineering: to calculate the capacity of infrastructure, e.g., how many lanes a bridge should have; to estimate the financial and social viability of projects, e.g., using cost–benefit analysis and social impact assessment; and to calculate environmental impacts, e.g., air pollution and noise.

Four-step models

Within the rational planning framework, transportation forecasts have traditionally followed the sequential four-step model or urban transportation planning (UTP) procedure, first implemented on mainframe computers in the 1950s at the Detroit Metropolitan Area Traffic Study and Chicago Area Transportation Study (CATS).

Land-use forecasting starts the process. Typically, forecasts are made for the region as a whole, e.g., of population growth. Such forecasts provide control totals for the local land use analysis. Typically, the region is divided into zones and by trend or regression analysis, the population and employment are determined for each.

The four steps of the classical urban transportation planning system model are:

After the classical model, there is an evaluation according to an agreed set of decision criteria and parameters. A typical criterion is cost–benefit analysis. Such analysis might be applied after the network assignment model identifies needed capacity: is such capacity worthwhile? In addition to identifying the forecasting and decision steps as additional steps in the process, it is important to note that forecasting and decision-making permeate each step in the UTP process. Planning deals with the future, and it is forecasting dependent.

Activity-based models

Activity-based models are another class of models that predict for individuals where and when specific activities (e.g. work, leisure, shopping, ...) are conducted.

Partial and fully operational activity-based simulation systems include:

The major premise behind activity-based models is that travel demand is derived from activities that people need or wish to perform, with travel decisions forming part of the scheduling decisions. Travel is then seen as just one of the attributes of a system. The travel model is therefore set within the context of an agenda, as a component of an activity scheduling decision.

Activity-based models offer other possibilities than four-step models, e.g. to model environmental issues such as emissions and exposure to air pollution. Although their obvious advantages for environmental purposes were recognized by Shiftan almost a decade ago,[6] applications to exposure models remain scarce. Activity-based models have recently been used to predict emissions [7] and air quality.[8] [9] They can also provide a better total estimate of exposure while also enabling the disaggregation of individual exposure over activities.[5][10] They can therefore be used to reduce exposure misclassification and establish relationships between health impacts and air quality more precisely.[11] Policy makers can use activity-based models to devise strategies that reduce exposure by changing time activity patterns or that target specific groups in the population.[12][13]

A method based on percolation theory was developed by Daqing Li [14] to characterize the global quality of traffic in a city. The method can be also used to identify significant and recurrent bottlenecks in different rush-hours.

Precursor steps

Although not identified as steps in the UTP process, a lot of data gathering is involved in the UTP analysis process. Census and land use data are obtained, along with home interview surveys and journey surveys. Home interview surveys, land use data, and special trip attraction surveys provide the information on which the UTP analysis tools are exercised.

Data collection, management, and processing; model estimation; and use of models to yield plans are much used techniques in the UTP process. In the early days, in the USA, census data was augmented that with data collection methods that had been developed by the Bureau of Public Roads (a predecessor of the Federal Highway Administration): traffic counting procedures, cordon "where are you coming from and where are you going" counts, and home interview techniques. Protocols for coding networks and the notion of analysis or traffic zones emerged at the CATS.

Model estimation used existing techniques, and plans were developed using whatever models had been developed in a study. The main difference between now and then is the development of some analytic resources specific to transportation planning, in addition to the BPR data acquisition techniques used in the early days.

Critique

The sequential and aggregate nature of transportation forecasting has come under much criticism. While improvements have been made, in particular giving an activity-base to travel demand, much remains to be done. In the 1990s, most federal investment in model research went to the Transims project at Los Alamos National Laboratory, developed by physicists. While the use of supercomputers and the detailed simulations may be an improvement on practice, they have yet to be shown to be better (more accurate) than conventional models. A commercial version was spun off to IBM,[15] and an open source version is also being actively maintained as TRANSIMS Open-Source.[16][17]

One of the major oversights in the use of transportation models in practice is the absence of any feedback from transportation models on land use. Highways and transit investments not only respond to land use, they shape it as well.

See also

Notes

  1. Arentze T & Timmermans H (2000). "A Learning-Based Transportation Oriented Simulation System". Transportation Research Part B. 38: 613–633.
  2. Hertkorn G (2005). "Mikroskopische Modellierung von zeitabhängiger Verkehrsnachfrage und von Verkehrsflußmustern" (PDF).
  3. Multi-Agent Transport Simulation Toolkit
  4. 1 2 Dhondt; et al. (2012). "Health impact assessment of air pollution using a dynamic exposure profile: Implications for exposure and health impact estimates". Environmental Impact Assessment Review. 36: 42–51. doi:10.1016/j.eiar.2012.03.004.
  5. Shiftan Y. (2000). "The advantage of activity-based modelling for air-quality purposes: theory vs practice and future needs". Innovation. 13 (1): 95–110. doi:10.1080/135116100111685.
  6. Beckx C, Arentze T, Int Panis L, Janssens D, Vankerkom J, Wets G (2009). "An integrated activity-based modelling framework to assess vehicle emissions: approach and application". Environment and Planning B: Planning and Design. 36 (6): 1086–1102. doi:10.1068/b35044.
  7. Beckx C, Int Panis L, Van De Vel K, Arentze T, Janssens D, Wets G (2009). "The contribution of activity-based transport models to air quality modelling: a validation of the ALBATROSS - AURORA model chain". Science of the Total Environment. 407: 3814–3822. doi:10.1016/j.scitotenv.2009.03.015.
  8. Hatzopoulou M, Miller E (2010). "Linking an activity-based travel demand model with traffic emission and dispersion models: Transport's contribution to air pollution in Toronto". Transportation Research Part D. 15: 315–325. doi:10.1016/j.trd.2010.03.007.
  9. Beckx C (2009). "Disaggregation of nation-wide dynamic population exposure estimates in The Netherlands: applications of activity-based transport models". Atmospheric Environment. 43 (34): 5454–5462. doi:10.1016/j.atmosenv.2009.07.035.
  10. Int Panis L (2010). "New Directions: Air pollution epidemiology can benefit from activity-based models". Atmospheric Environment. 44: 1003–1004. doi:10.1016/j.atmosenv.2009.10.047.
  11. Int Panis L, et al. (2009). "Socio-Economic Class and Exposure to NO2 Air Pollution in the Netherlands". Epidemiology. 20 (6): S19. doi:10.1097/01.ede.0000362234.56425.2c.
  12. Int Panis L, et al. (2009). "Modelling Gender Specific Exposure to Air Pollution". Epidemiology. 20 (6): S19. doi:10.1097/01.ede.0000362233.79296.95.
  13. Li, Daqing; Fu, Bowen; Wang, Yunpeng; Lu, Guangquan; Berezin, Yehiel; Stanley, H. Eugene; Havlin, Shlomo (2015). "Percolation transition in dynamical traffic network with evolving critical bottlenecks". Proceedings of the National Academy of Sciences. 112 (3): 669–672. doi:10.1073/pnas.1419185112. ISSN 0027-8424.
  14. Transims
  15. TRANSIMS Open-Source - Home
  16. Transportation Analysis and Simulation

References

External links

This article is issued from Wikipedia - version of the 10/7/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.