Searle's bar method

Searle's bar method (named after George Frederick Charles Searle) is an experimental procedure to measure thermal conductivity of material. A bar of material is being heated by steam on one side and the other side cooled down by water while the length of the bar is thermally insulated. Then the heat ΔQ propagating through the bar in a time interval of Δt is given by

\left({\frac {\Delta Q}{\Delta t}}\right)_{\mathrm {bar} }=-kA{\frac {\Delta T_{\mathrm {bar} }}{L}}

where

ΔQ is the heat supplied to the bar in time Δt
k is the coefficient of thermal conductivity of the bar.
A is the cross-sectional area of the bar,
ΔT_bar is the temperature difference of both ends of the bar
L is the length of the bar

and the heat ΔQ absorbed by water in a time interval of Δt is:

\left({\frac {\Delta Q}{\Delta t}}\right)_{\mathrm {water} }=C_{\mathrm {w} }{\frac {\Delta m}{\Delta t}}\Delta T_{\mathrm {water} }

where

C_w is the specific heat of water,
Δm is the mass of water collected during time Δt,
ΔT_water is difference in the temperature of water before and after it has gone through the bar.

Assuming perfect insulation and no energy loss, then

\left({\frac {\Delta Q}{\Delta t}}\right)_{\mathrm {bar} }=\left({\frac {\Delta Q}{\Delta t}}\right)_{\mathrm {water} }

which leads to

k=-C_{\mathrm {w} }{\frac {L}{A}}{\frac {\Delta m}{\Delta t}}{\frac {\Delta T_{\mathrm {water} }}{\Delta T_{\mathrm {bar} }}}

References

Davisson, M. (1997). "Searle's Bar (Thermal Conductivity of a Good Conductor)". University of Paisley.

This article is issued from Wikipedia - version of the 10/8/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.