Order of battle

Military organization
Typical units Typical numbers Typical commander
fireteam 3–4 corporal
squad/
section
8–12 sergeant
platoon 15–30 lieutenant
company 80–150 captain/major
battalion/
cohort
300–800 lieutenant colonel
regiment/
brigade
2,000–4,000 colonel/
brigadier general
division/
legion
10,000–15,000 major general
corps 20,000–40,000 lieutenant general
field army 80,000+ general
army group 2+ field armies field marshal/
five-star general
region/
theater
4+ army groups Six-star rank
NaviesArmiesAir forces
Commissioned and Non-commissioned officers
Admiral of
the fleet
Marshal or
Field marshal
Marshal of
the air force
AdmiralGeneralAir chief marshal
Vice admiralLieutenant generalAir marshal
Rear admiralMajor generalAir vice-marshal
CommodoreBrigadier or
Brigadier general
Air commodore
CaptainColonelGroup captain
CommanderLieutenant colonelWing commander
Lieutenant
commander
Major or
Commandant
Squadron leader
LieutenantCaptainFlight lieutenant
Sub-lieutenantLieutenant or
First lieutenant
Flying officer
EnsignSecond lieutenantPilot officer
MidshipmanOfficer cadetFlight cadet
Enlisted grades
Warrant officer or
Chief petty officer
Warrant officer or
Sergeant major
Warrant officer
Petty officerSergeantSergeant
Leading seamanCorporalCorporal
SeamanPrivateAircraftman

In modern use, the order of battle of an armed force participating in a military operation or campaign shows the hierarchical organization, command structure, strength, disposition of personnel, and equipment of units and formations of the armed force. Various abbreviations are in use, including OOB, O/B, or OB, while ORBAT remains the most common in the United Kingdom. An order of battle should be distinguished from a table of organisation, which is the intended composition of a given unit or formation according to the military doctrine of its armed force. As combat operations develop during a campaign, orders of battle may be revised and altered in response to the military needs and challenges. Also the known details of an order of battle may change during the course of executing the commanders' after action reports and/or other accounting methods (e.g. despatches) as combat assessment is conducted.

Historical approaches

In its original form during the Medieval period of European warfare, an order of battle was the order in which troops were positioned relative to the position of the army commander. The term was also applied to the disposition of ships in the line of battle during the age of sail. In the later transformation of its meaning during the European period of Early Modern warfare the order of battle came to mean the order in which the units manoeuvered or deployed onto the battlefield to form battle-lines, with the positioning on the right considered the place of greatest honour. This need to reflect the unit seniority led to the keeping of military staff records, in tabular form reflecting the compilation of units an army, their commanders, equipment, and locations on the battlefield.

During the Napoleonic wars the meaning of the order of battle changed yet again to reflect the changes in the composition of opposing forces during the battle owing to use of larger formations than in the previous century. Napoleon also instituted the staff procedure of maintaining accurate information about the composition of the enemy order of battle, and tables of organisation, and this later evolved into an important function and an organisational tool used by military intelligence to analyse enemy capability for combat.

British historical approach

British military history is the source of some of the earliest orders of battle in the English language, and due to the British Empire's involvement in global conflicts over several centuries the records of historical orders of battle provide an excellent source of study and understanding not only of the composition, but also of tactics and doctrines of the forces through their depiction in the orders of battle. The British Army and UK forces use the acronym ORBAT to describe the structure of both friendly and enemy forces.

Operation Quicksilver, part of the British deception plan for the Invasion of Normandy in World War II, fed German intelligence a combination of true and false information about troop deployments in Britain, causing the Germans to deduce an order of battle which suggested an invasion at the Pas-de-Calais instead of Normandy.

Clausewitz

Clausewitz defined the ‘order of battle’ as “that division and formation of the different arms into separate parts, or sections, of the whole Army, and that form of general position or disposition of those parts which is to be the norm throughout the whole campaign or war.”

Normally these tactics are exercised in peace and cannot be essentially modified when war breaks out. Order of battle belongs more to tactics than strategy. Clausewitz also noted that the order of battle depends on the effective span of control by a commander. Too few subunits makes an army unwieldy; too many subunits makes the ‘power of the superior will’ weak; and in addition every step by which an order has to pass weakens its effect by loss of force and longer time of transmission. Clausewitz recommended that armies have no more than eight to ten subunits and subordinate corps four to six subunits.[1]

United States Army

US 1st Infantry Division ORBAT during World War I

In United States Army standing operating procedures, an order of battle to be used for operations planning should relate what an Army unit might be expected to encounter while deployed in the field. The templating of the OoB during maneuvers is typically the responsibility of a battalion or brigade commander, conducted through their Headquarters S-2 (intelligence) sections. Observations about enemy troop movements may be gathered by various military intelligence resources from all echelons, including the employment of any attached special forces units (such as Rangers or LRS teams) as well as Cavalry RSTA squadrons.

From such intelligence data, the OOB section staff compiles a likely order of battle for a planning document or operations order by assessing the following factors:

Enemy's Composition, Disposition, Strength (often mnemonicized with SALUTE: Size, Activity, Location, Unit, Time, Equipment):

Enemy capabilities and limitations (often mnemonicized with DRAWD: Defend, Reinforce, Attack, Withdraw, Delay):

Enemy's Most Likely Course of Action (EMLCOA):

  • Personalities (known enemy personnel and their behaviour, often based on communications intelligence analysis)
  • Unit history used to judge expected performance based on its past performance
  • Uniforms and insignia to enable confirmation of the above data
US 1st Infantry Division ORBAT in 1989

A general rule in American military doctrine is that each unit should keep track of enemy subunits two echelons below its own: that is, a division should monitor enemy units confronting it down to the battalion, a brigade should monitor enemy units down to companies, and a battalion should monitor enemy forces down to platoons. General George S. Patton was one of the first to recommend this practice.

The United States military's intelligence capabilities in the 21st century have allowed for monitoring even further than two echelons down the chain of command. It is quite common for US forces at the battalion level to be able to identify the location and activities of not only enemy forces at the squad level but even individual vehicles. This situational awareness provides a more complete picture of the battlespace for both combatant commanders and tactical commanders.

Up until the end of the Cold War, determining realistic orders of battle was generally an orderly but extremely frustrating process for NATO because although the Warsaw Pact nations had well known doctrines, tactics, techniques and procedures, in actuality, the characteristics of Soviet forces fluctuated often, significantly, and changes often went undetected for years at below-division levels. The intelligence situation for Western militaries has been exacerbated today as they continue to be become engaged in operations against non-traditional enemies (insurgents, guerrillas, etc.) and compiling orders of battle for irregular forces becomes very difficult; the equivalent military intelligence output requiring an increase in acquired data and analysis effort to provide an accurate and timely picture to the commander.

Examples

Some examples of ORBATs in modern warfare can be found for the Invasion of Normandy, the Battle of Bình Giã during the Vietnam War, and the Battle of Al Faw during Operation Iraqi Freedom.

See also

References

  1. pp.272-276, Clausewitz

Sources

External links

This article is issued from Wikipedia - version of the 11/20/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.