New Zealand EW class locomotive

The New Zealand E^W class locomotive was a class of electric locomotive used in Wellington, New Zealand. The classification 'E^W' was due to their being electric locomotives allocated to Wellington. For two decades until the advent of the D^X class they were the most powerful locomotives in New Zealand.

Introduction

The Jacobs bogie and bellows of E^W 1806.

The E^W class were first ordered by New Zealand Railways from English Electric through their New Zealand agents Cory-Wright & Salmon in 1951 as a replacement for the earlier E^D class electric locomotives on passenger duties. It was felt that the E^D class was not suitable for this, and so English Electric was commissioned to build a twin-section articulated electric locomotive for use on the Wellington 1.5kV DC electrified system.

The new E^W class was the first locomotive class in New Zealand to utilise the Bo-Bo-Bo wheel arrangement, which would subsequently be copied on the Mitsubishi D^J class and Brush EF class. However, the E^W class was different in that the central Jacobs bogie was placed under the articulation of the two body halves with limited sideplay, whereas the D^J and EF classes have a single fixed body with sideplay in the central bogie.

During this time a proposal was made about building a Bo-Bo+Bo-Bo electric locomotive, which would essentially be a pair of E^W class locomotives permanently coupled together as one locomotive. This was initially classified E^WO, but later received the classification E^X. However, this did not proceed as the CME felt that it would not be possible to re-engineer the E^W class, which had been designed to work in Wellington, for the 1 in 33 gradients between Arthur's Pass and Otira. The locomotives would also need major alteration such as the fitting of rheostatic brakes, as used on the E^O class, and multiple-unit equipment.

It was intended that the E^W class would work on all trains in the Wellington area, as well as banking trains between Paekakariki and Pukerua Bay.

Service

The E^W class predominantly worked on passenger trains, particularly on suburban trains to the Hutt Valley and Paekakariki. They also ran in regular service hauling Main Trunk expresses between Wellington and Paekakariki, where they would be exchanged for a steam locomotive for the run north. They also were used to bank trains between Wellington and Paekakariki, although this work was more usually done by the older E^D class which were unsuited for passenger workings.

Less frequently, the E^W class also operated suburban shunting services, particularly on the Johnsonville Branch, where their flexible bodies and higher power output of 1,800 hp (1,300 kW) gave them a distinct advantage over the older E^D class. Much of this traffic was stock destined for the Raroa stockyard sidings, from where they would be driven to the Ngauranga Freezing Works nearby, while the remainder was general freight destined largely for Johnsonville.

The class was well liked by the railway unions as NZR had worked closely with them in the design phase of the E^W class. This led to the cabs being laid out in an ergonomic fashion which made them easy to operate, making them a favourite of the unions. They were also fairly reliable, and were also capable of generating twice their specified power output as evidenced by an NZR engineer during a test in the 1960s when E^W 1806 produced a power output of 3,600 hp.

Withdrawal

E^W 1806 at Ferrymead Heritage Park.

In the late 1960s, work was undertaken to lower the tunnel floors between Paekakariki and Wellington in order to allow the D^A class diesel locomotives to haul trains through to Wellington without having to stop at Paekakariki to be replaced by an E^D or E^W. The E^Ws continued to have a role in this, primarily as a banking locomotive.

In 1980, EW 159 (E^W 1805) was briefly sent to Otira following the Goat Creek washout, which had damaged three of the Toshiba EO class locomotives. During its time there the locomotive required its own driver as it lacked multiple-unit equipment. When the three rebuilt EOs returned, EW 159 was transferred back to Wellington. The following year, the decision was made by the CME to have EW 136 (E^W 1802), then under overhaul, withdrawn and scrapped. This was agreed to as the use of the EW class had decreased, and 136 became the first EW to be withdrawn.

The arrival of the EM class units in 1982 locomotive-hauled carriage trains were eliminated, with all carriage-hauled services ceasing in 1983 with the exception of the Masterton and Palmerston North services, which had been diesel-hauled since their inception. The last EW to haul a suburban train was EW 142(E^W 1803) from Paekakariki to Wellington on 11 February 1983. EW 142 ran an excursion known as The Suburban Rail Ranger to Johnsonville on 14 May 1983.

The EW class finished its working life on main line goods trains, banking DA or DX class locomotives between Wellington and Paekakariki with Train 778, the Wellington-Palmerston North petrol tank train, being a common assignment. This was the last service to use the EW class, concluding on 20 December 1983 when EW 142 banked DX 5477 on the last revenue operation of the EW class.^[1] All of the remaining locomotives were put into storage.

Storage

As the EW class was not worn out, NZR management decided to have the six remaining locomotives placed into interim storage until a new use could be found for them. Consideration was still being given to the EX class proposal, and so it was possible that the locomotives might be required once again. It was decided to store the locomotives in available locomotive sheds around the country which would provide secure, and where possible covered, storage.

The locomotives were dispersed as follows:

• EW 107 and EW 159 were moved to Stratford.
• EW 113 was moved to Addington Workshops.
• EW 142 and EW 165 were moved to the Hutt Workshops.
• EW 171 was moved to Timaru, before moving to Palmerston and then Hillside Workshops.

In 1988, the decision was made to move EW 171 north to Christchurch for possible conversion with EW 113 to become the prototype EX class locomotive. This did not eventuate, and it was donated to the Electric Traction Group at Ferrymead, arriving in time to take part in the Ferrymead 125 motive power cavalcade.

As NZ Rail was creating its Heritage Fleet at this time, it was decided to select an EW for preservation. EW 165 was chosen and was moved to Wellington for remedial work along with DE 1389 (D^E 508) prior to its official inclusion in the fleet. The remaining locomotives were scrapped; EW 107 and EW 159 were towed back to Hutt Workshops in 1988 where they joined EW 142 prior to being scrapped. EW 113 went to Linwood for a period before it was later towed to a siding at Woolston alongside the South Island Main Trunk where it remained for a short time before being scrapped in early 1990.

Preservation

The first EW class locomotive to be preserved, E^W 1806 (TMS EW 171), was donated to the Canterbury Railway Society in 1988. It is based at Ferrymead Heritage Park and is nominally operational, although it is not permitted to run in active service at Ferrymead and is confined to moving at slow speed from the electric locomotive shed onto the main line connection beside the Moorhouse station for display when in operation. It has been renumbered as E^W 1806, and carries this identity on its headstocks only.

The other, EW 165 (E^W 1805), was based in Wellington, originally in the old NZR Parcels depot on Platform 9 of Wellington Station, before moving to the Carriage and Wagon workshop near the Thorndon overpass. It retained its TMS identity of EW 165 throughout, until the decision was made to disperse the Heritage Fleet in 2004. The EW was not sold until August 2005 when it was purchased by Ian Welch of the Mainline Steam Heritage Trust. The locomotive made one final run under then-Toll Rail ownership on 21 August 2005 when it was driven by veteran locomotive driver Fred Hamer from Wellington to Paekakariki. It was then towed by DCP 4611 to Mainline's Plimmerton depot.

Since arrival, EW 165 has been restored as E^W 1805 complete with replica number plates. It is intended that the locomotive will be used to operate suburban railfan trips around Wellington when the overhaul is finished, although this is pending certification and the construction of a suitable length of overhead into the depot to allow 1805 to move around. The locomotive was revealed as E^W 1805 over Labour Weekend 2008 when it was towed to Feilding to take part in the NIMT cetenary celebrations.

Class register

Accidents

The E^W class have been involved in three major accidents during their service lives:

• 1963 - E^W 1806 runs into a slip on the line near Pukerua Bay and derails.
• 1964 - E^W 1803 hauling an empty suburban service collides with Bagnall D^SA 248 hauling a shunt at Taita railway station. The driver on the E^W passed a signal at danger, and was subsequently fired.
• 1975 - E^W 1805 overruns the buffers at Wellington Railway Station. It was discovered the cocks on the air-brake hoses on the second carriage had been closed during shunting, limiting the operation of the air-brakes to the locomotive and first carriage only. The N^O 2 end of the E^W was subsequently rebuilt with a new style of window different from the standard E^W type windows, and retains this modification today in preservation.

See also

• JR Freight Class EH200
• JR Freight Class EH500

References

• Parsons, David; New Zealand Railway Motive Power 2002, NZRLS, 2002
• Heath, Eric, and Stott, Bob; Classic Steam Locomotives Of New Zealand, Grantham House, 1993

External links

• New Zealand Diesel and Electric Traction - Class EW