Butanone

Butanone[1]
Names
Preferred IUPAC name
Butan-2-one[2]
Other names
Ethyl methyl ketone[2]
Methyl ethyl ketone (not recommended[2])
MEK
2-Butanone
Methylpropanone
Ethylmethylketone
Methylacetone
Identifiers
78-93-3 YesY
3D model (Jmol) Interactive image
Interactive image
741880
ChEBI CHEBI:28398 YesY
ChEMBL ChEMBL15849 YesY
ChemSpider 6321 YesY
ECHA InfoCard 100.001.054
25656
KEGG C02845 YesY
PubChem 6569
RTECS number EL6475000
UNII 6PT9KLV9IO YesY
Properties
C4H8O
Molar mass 72.11 g·mol−1
Appearance Colorless liquid
Odor mint or acetone-like[3]
Density 0.8050 g/mL
Melting point −86 °C (−123 °F; 187 K)
Boiling point 79.64 °C (175.35 °F; 352.79 K)
27.5 g/100 mL
Vapor pressure 78 mmHg (20°C)[3]
Acidity (pKa) 14.7
1.37880
Viscosity 0.43 cP
Structure
2.76 D
Hazards
Safety data sheet See: data page
Flammable (F)
Irritant (Xi)
R-phrases R11 R36 R66 R67
S-phrases (S2) S9 S16
NFPA 704
Flammability code 3: Liquids and solids that can be ignited under almost all ambient temperature conditions. Flash point between 23 and 38 °C (73 and 100 °F). E.g., gasoline) Health code 1: Exposure would cause irritation but only minor residual injury. E.g., turpentine Reactivity code 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g., liquid nitrogen Special hazards (white): no codeNFPA 704 four-colored diamond
3
1
0
Flash point −9 °C (16 °F; 264 K)
505 °C (941 °F; 778 K)
Explosive limits 1.4%-11.4%[3]
Lethal dose or concentration (LD, LC):
2737 mg/kg (oral, rat)
4050 mg/kg (oral, mouse)[4]
12667 ppm (mammal)
13333 ppm (mouse, 2 hr)
7833 ppm (rat, 8 hr)[4]
US health exposure limits (NIOSH):
PEL (Permissible)
 TWA 200 ppm (590 mg/m3)[3]
REL (Recommended)
 TWA 200 ppm (590 mg/m3) ST 300 ppm (885 mg/m3)[3]
IDLH (Immediate danger)
 3000 ppm[3]
Related compounds
Related Ketones
 Acetone; 3-pentanone; 3-Methylbutanone
Supplementary data page
Refractive index (n),
Dielectric constant (εr), etc.
Thermodynamic
data
 Phase behaviour
solid–liquid–gas
UV, IR, NMR, MS
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
YesY verify (what is YesYN ?)
Infobox references

Butanone, also known as methyl ethyl ketone (MEK), is an organic compound with the formula CH3C(O)CH2CH3. This colorless liquid ketone has a sharp, sweet odor reminiscent of butterscotch and acetone. It is produced industrially on a large scale, and also occurs in trace amounts in nature.[5] It is soluble in water and is commonly used as an industrial solvent.[6]

Production

Butanone may be produced by oxidation of 2-butanol. The dehydrogenation of 2-butanol using a catalyst is catalyzed by copper, zinc, or bronze:

CH3CH(OH)CH2CH3 → CH3C(O)CH2CH3 + H2

This is used to produce approximately 700 million kilograms yearly. Other syntheses that have been examined but not implemented include Wacker oxidation of 2-butene and oxidation of isobutylbenzene, which is analogous to the industrial production of acetone.[5]

Both liquid-phase oxidation of heavy naphtha and the Fischer-Tropsch reaction produce mixed oxygenate streams, from which 2-butanone is extracted by fractionation.[7]

Butanone is biosynthesized by some trees and found in some fruits and vegetables in small amounts. It is released to the air from car and truck exhausts.

Applications

As a solvent

Butanone is an effective and common solvent[6] and is used in processes involving gums, resins, cellulose acetate and nitrocellulose coatings and in vinyl films.[8] For this reason it finds use in the manufacture of plastics, textiles, in the production of paraffin wax, and in household products such as lacquer, varnishes, paint remover, a denaturing agent for denatured alcohol, glues, and as a cleaning agent. It has similar solvent properties to acetone but boils at a higher temperature and has a significantly slower evaporation rate.[9] Butanone is also used in dry erase markers as the solvent of the erasable dye.

As a plastic welding agent

As butanone dissolves polystyrene and many other plastics, it is sold as "model cement" for use in connecting parts of scale model kits. Though often considered an adhesive, it is actually functioning as a welding agent in this context.

Other uses

Butanone is the precursor to methyl ethyl ketone peroxide, which is a catalyst for some polymerization reactions such as crosslinking of unsaturated polyester resins.

Safety

Flammability

Butanone can react with most oxidizing materials, and can produce fires.[6] It is moderately explosive; it requires only a small flame or spark to cause a vigorous reaction.[6] Butanone fires should be extinguished with carbon dioxide, dry agents, or alcohol-resistant foam.[6] Concentrations in the air high enough to be flammable are intolerable to humans due to the irritating nature of the vapor.[9]

Health effects

Butanone is an irritant, causing irritation to the eyes and nose of humans.[9] Serious health effects in animals have been seen only at very high levels. These included skeletal birth defects and low birth weight in mice, when they inhaled it at the highest dose tested (3000 ppm for 7 hours/day).[10] There are no long-term studies with animals breathing or drinking it,[11] and no studies for carcinogenicity in animals breathing or drinking it.[12]:96 There is some evidence that methyl ethyl ketone can potentiate the toxicity of other solvents, in contrast to the calculation of mixed solvent exposures by simple addition of exposures.[13] As of 2010, some reviewers advised caution in using methylethyl ketone because of reports of neuropsychological effects. [14]

Butanone is listed as a Table II precursor under the United Nations Convention Against Illicit Traffic in Narcotic Drugs and Psychotropic Substances.[15]

Regulation

Emission of butanone was regulated in the US as a hazardous air pollutant, because it is a volatile organic compound contributing to the formation of tropospheric (ground-level) ozone. In 2005, the U. S. Environmental Protection Agency removed butanone from the list of hazardous air pollutants (HAPs). [16][17][18]

See also

References

  1. ↑ Merck Index, 11th Edition, 5991.
  2. 1 2 3 Nomenclature of Organic Chemistry : IUPAC Recommendations and Preferred Names 2013 (Blue Book). Cambridge: The Royal Society of Chemistry. 2014. p. 725. doi:10.1039/9781849733069-FP001. ISBN 978-0-85404-182-4.
  3. 1 2 3 4 5 6 "NIOSH Pocket Guide to Chemical Hazards #0069". National Institute for Occupational Safety and Health (NIOSH).
  4. 1 2 "2-Butanone". Immediately Dangerous to Life and Health. National Institute for Occupational Safety and Health (NIOSH).
  5. 1 2 Wilhelm Neier, Guenter Strehlke "2-Butanone" in Ullmann's Encyclopedia of Industrial Chemistry, Wiley-VCH, Weinheim, 2002.
  6. 1 2 3 4 5 Turner, Charles F.; McCreery, Joseph W. (1981). The Chemistry of Fire and Hazardous Materials. Boston, Massachusetts: Allyn and Bacon, Inc. p. 118. ISBN 0-205-06912-6.
  7. ↑ Ashford's Dictionary of Industrial Chemicals, Third edition, 2011, ISBN 978-0-9522674-3-0, pages 6013-4
  8. ↑ Apps, E. A. (1958). Printing Ink Technology. London: Leonard Hill [Books] Limited. p. 101.
  9. 1 2 3 Fairhall, Lawrence T. (1957). Industrial Toxicology. Baltimore: The Williams and Wilkins Company. pp. 172–173.
  10. ↑ Schwetz; et al. (1991). "Developmental toxicity of inhaled methyl ethyl ketone in Swiss mice". Fund. Appl. Toxicol. 16 (4): 742–748. doi:10.1016/0272-0590(91)90160-6.
  11. ↑ "Methyl ethyl ketone (MEK) (CASRN 78-93-3)". Integrated Risk Information System (IRIS). EPA. 26 September 2003. Retrieved 16 March 2015.
  12. ↑ "U.S.Toxicological review of Methyl ethyl ketone In Support of Summary Information on the Integrated Risk Information System (IRIS)" (PDF). U.S. Environmental Protection Agency. September 2003. p. 152. Retrieved 16 March 2015.
  13. ↑ F D Dick. Solvent neurotoxicity, Occup Environ Med. 2006 Mar; 63(3): 221–226. doi: 10.1136/oem.2005.022400, PMCID: PMC2078137
  14. ↑ Thompson, S.B.N. “Implications for cognitive rehabilitation and brain injury from exposure to Methyl Ethyl Ketone (MEK): a review.” Journal of Cognitive Rehabilitation 2010; 28(Winter): 4-14. doi: jofcr.com/vol284/v28i4thompson.pdf.
  15. ↑ List of Precursors and Chemicals Frequently Used in the Illicit Manufacture of Narcotic Drugs and Psychotropic Substances Under International Control Archived February 27, 2008, at the Wayback Machine., International Narcotics Control Board
  16. ↑ Federal Register Volume 70, Issue 242 (December 19, 2005)
  17. ↑ Barbara Kanegsberg (n.d.). "MEK No Longer a HAP". Bfksolutions newsletter. Archived from the original on 2 April 2015. Retrieved 2 April 2015. After technical review and consideration of public comments, EPA concluded that potential exposures to butanone emitted from industrial processes may not reasonably be anticipated to cause human health or environmental problems.
  18. ↑ "EPA De-Lists MEK from CAA HAP List". www.pcimag.com. Retrieved 2016-07-30.
This article is issued from Wikipedia - version of the 11/18/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.