Erewash Canal

A View of the Erewash Canal above Eastwood Lock (Lock 1) at a place known locally as The Gudgeon

The Erewash Canal i/ˈɛrəwɒʃ/ is a broad canal in Derbyshire, England. It runs just under 12 miles (19 km) and has 14 locks. The first lock at Langley Bridge is actually part of the Cromford Canal.

Origins

Erewash Aqueduct near Shipley Gate in 2007
Erewash Canal
Legend
18.3km River Trent
18.2km Trent Lock (No.60)
17.1km Sheet Stores Arm
15.5km Long Eaton Lock (No.61)
13.9km Dockholme Lock (No.62)
13.1km Sandiacre Lock (No.63)
13.05km Derby Canal from Derby
10.8km Sandiacre Pasture Lock (No.64)
10.25km M1 overpass
9.8km Stanton Lock (No.65)
9.6km Nutbrook Canal Joining from Shipley
9.1km Hallam Fields Lock (No.66)
7.8km Gallows Inn Lock (No.67)
6.95km Greens Lock (No.68)
6.5km Potters Lock (No.69)
4.8km Barker's Lock (No.70)
4.35km Stensons Lock (No.71)
2.13km Shipley Lock (No.72)
2km Aqueduct over River Erewash20 m
1.6km Eastwood Lock (No.73)
Erewash Canal to River Trent
0km Langley Bridge Lock (Cromford No.14)
Nottingham Canal branching to Nottingham
23km Langley Mill Basin
Cromford Canal in use until 1944
Butterley Tunnel2712 m
Cromford Canal in use until 1944
Cromford Basin

The canal obtained its act of parliament in 1777 with John Varley appointed as engineer and John and James Pinkerton the main contractors, it was completed in 1779 at a cost of £21,000 (£2,545,310 in 2015),[1]. It was a commercial success from the start mainly transporting coal.

The canal's success kept it going far longer than many of its contemporaries in the face of competition from the railways. When the Grand Union Canal Company took over the running of the Erewash in 1932 it was still a going concern. The canal was nationalised in 1947. By this time the closure of feeder canals resulting in a loss of trade and competition from other forms of transport was making itself felt and the last commercial narrowboat delivered its cargo in 1952. In 1962 the British Transport Commission closed the top section of canal. However, it was kept in water to supply the lower half of the canal and it remained navigable.

The main line from Long Eaton to Langley Mill was one of seven stretches of canal, formally designated as remainder waterways, which were re-classified by the British Waterways Act of 8 February 1983. Under the act, a total of 82 route miles (132 km) were upgraded to Cruising Waterway Standard.[2]

Shipley Wharf

At the turn of the twentieth century Shipley Wharf directly above Shipley Lock was very busy with the transhipment of coal from railway wagons which had descended an incline from the Shipley Collieries to narrowboats on the Erewash Canal. There was also a much earlier wagonway which connected the Shipley collieries to Shipley wharf between the completion of the Erewash Canal in 1779 and the completion of the Nutbrook Canal in 1796, from which point in time the Nutbrook Canal took this traffic. The incline in use at the end of the nineteenth century was originally built to connect the Shipley Collieries, then owned by the Miller-Mundy family with the Midland Railway's Erewash Valley railway line and was operated for this purpose between 1848 and 1870. Problems with the Nutbrook Canal's water supply instigated the re-laying of rails on the incline and its extension under the Midland Railway's Erewash Valley line and under the Midland Railway's Eastwood Colliery branch line, to Shipley Wharf. Coal was loaded into narrowboats here from 1895 until 1942. The sidings at the wharf were laid in a triangle. The coal wagons descended the incline under braking relying on gravity and accumulated momentum to carry them to the sidings where they were connected to an endless rope kept in motion by a stationary steam engine in the centre of the triangle. The endless rope went around three wheels at the corners of the triangle. One was sited on the Erewash Canal's aqueduct which spanned the Erewash River, a second was under the bridge which carried the Eastwood Colliery's branch line over the Shipley line and the third was alongside Eastwood Lock. Using this mechanism the colliery wagons were brought alongside the wharf and could be emptied directly into waiting narrowboats.[3]

Eastwood Colliery

Eastwood Colliery was situated on a narrow plot of land sandwiched between the Nottingham Canal and the Erewash Canal just above the Erewash Canal's Eastwood Lock. It was originally owned by Doctor Manson but was taken over by Barber Walker and Company. It was served by a branch line from the Great Northern Railway departing the main line close to Newthorpe and Greasley railway station. The colliery was also served by a branch line of the Midland Railway's Erewash Valley line departing the main line at Shipley Gate. Some of the embankments of the two branches are still in existence. The bridge abutments for the Midland Railway's wooden bridge which once stood directly below the Eastwood Lock can still be seen. The colliery was therefore, well served with transport options with the choice of two canals and two railways to export their coal. The Great Northern Railway branch crossed the Nottingham Canal using a swing bridge. The railway swing bridge no longer exists but the pedestrian bridge built next to it is still in use. Excessive water underground brought about the mine's closure in about 1884.[4]

The Canal Today

It starts from the River Trent at Trentlock, then goes through Long Eaton. After Long Eaton it runs roughly parallel to the River Erewash, past Sandiacre and Ilkeston, crossing the Erewash near Eastwood. The canal finally ends at the Langley Mill (Great Northern) basin, where it joins the Nottingham Canal and the Cromford Canal (both currently in a state of abandonment).

In 1968 the Erewash Canal Preservation & Development Association (ECP&DA) was formed in response to a threat by the British Waterways Board to close the canal. One of the ECP&DA's achievements was the re-opening of the Great Northern Basin at Langley Mill. This canal basin was the point at which the Cromford, Erewash and Nottingham Canals met. The Langley Mill Boat Company formed in 1974 and based at the Great Northern Basin has cleared and put back into water a short section of the Cromford Canal[5] connected to the basin. Today the Erewash Canal is fully open and is actively used by pleasure cruisers. At present [2006] the section of canal running through Long Eaton is oft frequented by pleasure craft; the factories which follow the canal along the Northern march of the town are no longer associated with the waterway, and fencing separates them from it.

However, these factories only block the western bank of the canal. The towpath, which follows the eastern bank, carries Route 67 of the National Cycle Network between the Lawrence Street access and Stanton Lock where the cycle route diverges to follow the Nutbrook Valley.

The canal is also regularly restocked with fish for anglers, and along the eastern tow path dozens of anglers are often seen.

See also

References

  1. UK CPI inflation numbers based on data available from Gregory Clark (2016), "The Annual RPI and Average Earnings for Britain, 1209 to Present (New Series)" MeasuringWorth.
  2. Lewis A. Edwards, (1985), Inland Waterways of Great Britain, 6th Ed, Imray Laurie Norie & Wilson, ISBN 0-85288-081-2
  3. Peter Stevenson and Ike Argent. Gateway to the Erewash Canal. Erewash Canal Preservation and Development Association.
  4. Henshaw, Alfred (2000). The Great Northern Railway in the East Midlands. RCTS. ISBN 0-901115-88-6.
    • H. Potter. The Cromford Canal.

Further reading

External links

Route map: Bing / Google

KML is from Wikidata
This article is issued from Wikipedia - version of the 4/8/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.