# Discharge (hydrology)

In hydrology, **discharge** is the volume rate of water flow that is transported through a given cross-sectional area.^{[1]} It includes any suspended solids (e.g. sediment), dissolved chemicals (e.g. CaCO_{3}_{(aq)}), or biologic material (e.g. diatoms) in addition to the water itself.

Synonyms vary by discipline, for example, a fluvial hydrologist studying natural river systems may define discharge as streamflow, whereas an engineer operating a reservoir system might define discharge as **outflow**, which is contrasted with inflow.

## Theory and calculation

GH Dury and MJ Bradshaw are two hydrologists who devised models showing the relationship between discharge and other variables in a river. The Bradshaw model described how pebble size and other variables change from source to mouth; while Dury considered the relationships between discharge and variables such as stream slope and friction.

The units that are typically used to express discharge include m³/s (cubic meters per second), ft³/s (cubic feet per second or cfs) and/or acre-feet per day.^{[2]} For example, the average discharge of the Rhine river in Europe is 2,200 cubic metres per second (78,000 cu ft/s) or 190,000,000 cubic metres (150,000 acre·ft) per day.

A commonly applied methodology for measuring, and estimating, the discharge of a river is based on a simplified form of the continuity equation. The equation implies that for any incompressible fluid, such as liquid water, the discharge (Q) is equal to the product of the stream's cross-sectional area (A) and its mean velocity (), and is written as:

where

- is the discharge ([L
^{3}T^{−1}]; m^{3}/s or ft^{3}/s) - is the cross-sectional area of the portion of the channel occupied by the flow ([L
^{2}]; m^{2}or ft^{2}) - is the average flow velocity ([LT
^{−1}]; m/s or ft/s)

## Catchment discharge

The catchment of a river above a certain location is determined by the surface area of all land which drains toward the river from above that point. The river's discharge at that location depends on the rainfall on the catchment or drainage area and the inflow or outflow of groundwater to or from the area, stream modifications such as dams and irrigation diversions, as well as evaporation and evapotranspiration from the area's land and plant surfaces. In storm hydrology, an important consideration is the stream's discharge hydrograph, a record of how the discharge varies over time after a precipitation event. The stream rises to a peak flow after each precipitation event, then falls in a slow recession. Because the peak flow also corresponds to the maximum water level reached during the event, it is of interest in flood studies. Analysis of the relationship between precipitation intensity and duration and the response of the stream discharge are aided by the concept of the unit hydrograph, which represents the response of stream discharge over time to the application of a hypothetical "unit" amount and duration of rainfall (e.g., half an inch over one hour). The amount of precipitation correlates to the volume of water (depending on the area of the catchment) that subsequently flows out of the river. Using the unit hydrograph method, actual historical rainfalls can be modeled mathematically to confirm characteristics of historical floods, and hypothetical "design storms" can be created for comparison to observed stream responses.

The relationship between the discharge in the stream at a given cross-section and the level of the stream is described by a rating curve. Average velocities and the cross-sectional area of the stream are measured for a given stream level. The velocity and the area give the discharge for that level. After measurements are made for several different levels, a rating table or rating curve may be developed. Once rated, the discharge in the stream may be determined by measuring the level, and determining the corresponding discharge from the rating curve. If a continuous level-recording device is located at a rated cross-section, the stream's discharge may be continuously determined.

Larger flows (higher discharges) can transport more sediment and larger particles downstream than smaller flows due to their greater force. Larger flows can also erode stream banks and damage public infrastructure.

## See also

- List of rivers by discharge
- Volumetric flow rate
- Groundwater discharge
- Submarine groundwater discharge
- Stream gauge

## References

- ↑ Buchanan, T.J. and Somers, W.P., 1969, Discharge Measurements at Gaging Stations: U.S. Geological Survey Techniques of Water-Resources Investigations, Book 3, Chapter A8, p. 1.
- ↑ Dunne, T., and Leopold, L.B., 1978, Water in Environmental Planning: San Francisco, Calif., W.H. Freeman, pp. 257–258.

## External links

- USDA NRCS National Engineering Handbook, Stage Discharge Relationships, Ch. 14
- USDA NRCS National Engineering Handbook